• Decrease font size
  • Return font size to normal
  • Increase font size
U.S. Department of Health and Human Services

CFR - Code of Federal Regulations Title 21

  • Print
  • Share
  • E-mail
-

The information on this page is current as of April 1 2019.

For the most up-to-date version of CFR Title 21, go to the Electronic Code of Federal Regulations (eCFR).

New Search
Help | More About 21CFR
[Code of Federal Regulations]
[Title 21, Volume 7]
[Revised as of April 1, 2019]
[CITE: 21CFR600]





TITLE 21--FOOD AND DRUGS
CHAPTER I--FOOD AND DRUG ADMINISTRATION
DEPARTMENT OF HEALTH AND HUMAN SERVICES
SUBCHAPTER F--BIOLOGICS
 
PART 600BIOLOGICAL PRODUCTS: GENERAL
 

Subpart A--General Provisions

Sec. 600.2 Mailing addresses.

(a) Licensed biological products regulated by the Center for Biologics Evaluation and Research (CBER). Unless otherwise stated in paragraph (c) of this section, or as otherwise prescribed by FDA regulation, all submissions to CBER referenced in parts 600 through 680 of this chapter, as applicable, must be sent to: Food and Drug Administration, Center for Biologics Evaluation and Research, Document Control Center, 10903 New Hampshire Ave., Bldg. 71, Rm. G112, Silver Spring, MD 20993-0002. Examples of such submissions include: Biologics license applications (BLAs) and their amendments and supplements, biological product deviation reports, fatality reports, and other correspondence. Biological products samples must not be sent to this address but must be sent to the address in paragraph (c) of this section.

(b) Licensed biological products regulated by the Center for Drug Evaluation and Research (CDER). Unless otherwise stated in paragraphs (b)(1), (b)(2), or (c) of this section, or as otherwise prescribed by FDA regulation, all submissions to CDER referenced in parts 600, 601, and 610 of this chapter, as applicable, must be sent to: CDER Central Document Room, Center for Drug Evaluation and Research, Food and Drug Administration, 5901B Ammendale Rd., Beltsville, MD 20705. Examples of such submissions include: BLAs and their amendments and supplements, and other correspondence.

(1) Biological Product Deviation Reporting (CDER). All biological product deviation reports required under 600.14 must be sent to: Division of Compliance Risk Management and Surveillance, Office of Compliance, Center for Drug Evaluation and Research, Food and Drug Administration, 10903 New Hampshire Ave., Silver Spring, MD 20993-0002.

(2) Advertising and Promotional Labeling (CDER). All advertising and promotional labeling supplements required under 601.12(f) of this chapter must be sent to: Division of Drug Marketing, Advertising and Communication, Center for Drug Evaluation and Research, Food and Drug Administration, 5901-B Ammendale Rd., Beltsville, MD 20705-1266.

(c) Samples and Protocols for licensed biological products regulated by CBER or CDER. (1) Biological product samples and/or protocols, other than radioactive biological product samples and protocols, required under 600.13, 600.22, 601.15, 610.2, 660.6, 660.36, or 660.46 of this chapter must be sent by courier service to: Food and Drug Administration, Center for Biologics Evaluation and Research, ATTN: Sample Custodian, 10903 New Hampshire Ave., Bldg. 75, Rm. G707, Silver Spring, MD 20993-0002. The protocol(s) may be placed in the box used to ship the samples to CBER. A cover letter should not be included when submitting the protocol with the sample unless it contains pertinent information affecting the release of the lot.

(2) Radioactive biological products required under 610.2 of this chapter must be sent by courier service to: Food and Drug Administration, Center for Biologics Evaluation and Research, ATTN: Sample Custodian, c/o White Oak Radiation Safety Program, 10903 New Hampshire Ave., Bldg. 52-72, Rm. G406A, Silver Spring, MD 20993-0002.

(d) Address information for submissions to CBER and CDER other than those listed in parts 600 through 680 of this chapter are included directly in the applicable regulations.

(e) Obtain updated mailing address information for biological products regulated by CBER at http://www.fda.gov/BiologicsBloodVaccines/default.htm , or for biological products regulated by CDER at http://www.fda.gov/Drugs/default.htm.

[70 FR 14981, Mar. 24, 2005, as amended at 74 FR 13114, Mar. 26, 2009; 78 FR 19585, Apr. 2, 2013; 80 FR 18091, Apr. 3, 2015; 79 FR 33090, June 10, 2014]

Sec. 600.3 Definitions.

As used in this subchapter:

(a) Act means the Public Health Service Act (58 Stat. 682), approved July 1, 1944.

(b) Secretary means the Secretary of Health and Human Services and any other officer or employee of the Department of Health and Human Services to whom the authority involved has been delegated.

(c) Commissioner of Food and Drugs means the Commissioner of the Food and Drug Administration.

(d) Center for Biologics Evaluation and Research means Center for Biologics Evaluation and Research of the Food and Drug Administration.

(e) State means a State or the District of Columbia, Puerto Rico, or the Virgin Islands.

(f) Possession includes among other possessions, Puerto Rico and the Virgin Islands.

(g) Products includes biological products and trivalent organic arsenicals.

(h) Biological product means any virus, therapeutic serum, toxin, antitoxin, or analogous product applicable to the prevention, treatment or cure of diseases or injuries of man:

(1) A virus is interpreted to be a product containing the minute living cause of an infectious disease and includes but is not limited to filterable viruses, bacteria, rickettsia, fungi, and protozoa.

(2) A therapeutic serum is a product obtained from blood by removing the clot or clot components and the blood cells.

(3) A toxin is a product containing a soluble substance poisonous to laboratory animals or to man in doses of 1 milliliter or less (or equivalent in weight) of the product, and having the property, following the injection of non-fatal doses into an animal, of causing to be produced therein another soluble substance which specifically neutralizes the poisonous substance and which is demonstrable in the serum of the animal thus immunized.

(4) An antitoxin is a product containing the soluble substance in serum or other body fluid of an immunized animal which specifically neutralizes the toxin against which the animal is immune.

(5) A product is analogous:

(i) To a virus if prepared from or with a virus or agent actually or potentially infectious, without regard to the degree of virulence or toxicogenicity of the specific strain used.

(ii) To a therapeutic serum, if composed of whole blood or plasma or containing some organic constituent or product other than a hormone or an amino acid, derived from whole blood, plasma, or serum.

(iii) To a toxin or antitoxin, if intended, irrespective of its source of origin, to be applicable to the prevention, treatment, or cure of disease or injuries of man through a specific immune process.

(i) Trivalent organic arsenicals means arsphenamine and its derivatives (or any other trivalent organic arsenic compound) applicable to the prevention, treatment, or cure of diseases or injuries of man.

(j) A product is deemed applicable to the prevention, treatment, or cure of diseases or injuries of man irrespective of the mode of administration or application recommended, including use when intended through administration or application to a person as an aid in diagnosis, or in evaluating the degree of susceptibility or immunity possessed by a person, and including also any other use for purposes of diagnosis if the diagnostic substance so used is prepared from or with the aid of a biological product.

(k) Proper name, as applied to a product, means the name designated in the license for use upon each package of the product.

(l) Dating period means the period beyond which the product cannot be expected beyond reasonable doubt to yield its specific results.

(m) Expiration date means the calendar month and year, and where applicable, the day and hour, that the dating period ends.

(n) The word standards means specifications and procedures applicable to an establishment or to the manufacture or release of products, which are prescribed in this subchapter or established in the biologics license application designed to insure the continued safety, purity, and potency of such products.

(o) The word continued as applied to the safety, purity and potency of products is interpreted to apply to the dating period.

(p) The word safety means the relative freedom from harmful effect to persons affected, directly or indirectly, by a product when prudently administered, taking into consideration the character of the product in relation to the condition of the recipient at the time.

(q) The word sterility is interpreted to mean freedom from viable contaminating microorganisms, as determined by the tests conducted under 610.12 of this chapter.

(r) Purity means relative freedom from extraneous matter in the finished product, whether or not harmful to the recipient or deleterious to the product. Purity includes but is not limited to relative freedom from residual moisture or other volatile substances and pyrogenic substances.

(s) The word potency is interpreted to mean the specific ability or capacity of the product, as indicated by appropriate laboratory tests or by adequately controlled clinical data obtained through the administration of the product in the manner intended, to effect a given result.

(t) Manufacturer means any legal person or entity engaged in the manufacture of a product subject to license under the act; "Manufacturer" also includes any legal person or entity who is an applicant for a license where the applicant assumes responsibility for compliance with the applicable product and establishment standards.

(u) Manufacture means all steps in propagation or manufacture and preparation of products and includes but is not limited to filling, testing, labeling, packaging, and storage by the manufacturer.

(v) Location includes all buildings, appurtenances, equipment and animals used, and personnel engaged by a manufacturer within a particular area designated by an address adequate for identification.

(w) Establishment has the same meaning as "facility" in section 351 of the Public Health Service Act and includes all locations.

(x) Lot means that quantity of uniform material identified by the manufacturer as having been thoroughly mixed in a single vessel.

(y) A filling refers to a group of final containers identical in all respects, which have been filled with the same product from the same bulk lot without any change that will affect the integrity of the filling assembly.

(z) Process refers to a manufacturing step that is performed on the product itself which may affect its safety, purity or potency, in contrast to such manufacturing steps which do not affect intrinsically the safety, purity or potency of the product.

(aa) Selling agent or distributor means any person engaged in the unrestricted distribution, other than by sale at retail, of products subject to license.

(bb) Container (referred to also as "final container") is the immediate unit, bottle, vial, ampule, tube, or other receptacle containing the product as distributed for sale, barter, or exchange.

(cc) Package means the immediate carton, receptacle, or wrapper, including all labeling matter therein and thereon, and the contents of the one or more enclosed containers. If no package, as defined in the preceding sentence, is used, the container shall be deemed to be the package.

(dd) Label means any written, printed, or graphic matter on the container or package or any such matter clearly visible through the immediate carton, receptacle, or wrapper.

(ee) Radioactive biological product means a biological product which is labeled with a radionuclide or intended solely to be labeled with a radionuclide.

(ff) Amendment is the submission of information to a pending license application or supplement, to revise or modify the application as originally submitted.

(gg) Supplement is a request to approve a change in an approved license application.

(hh) Distributed means the biological product has left the control of the licensed manufacturer.

(ii) Control means having responsibility for maintaining the continued safety, purity, and potency of the product and for compliance with applicable product and establishment standards, and for compliance with current good manufacturing practices.

(jj) Assess the effects of the change , as used in 601.12 of this chapter, means to evaluate the effects of a manufacturing change on the identity, strength, quality, purity, and potency of a product as these factors may relate to the safety or effectiveness of the product.

(kk) Specification , as used in 601.12 of this chapter, means the quality standard (i.e., tests, analytical procedures, and acceptance criteria) provided in an approved application to confirm the quality of products, intermediates, raw materials, reagents, components, in-process materials, container closure systems, and other materials used in the production of a product. For the purpose of this definition, acceptance criteria means numerical limits, ranges, or other criteria for the tests described.

(ll) Complete response letter means a written communication to an applicant from FDA usually describing all of the deficiencies that the agency has identified in a biologics license application or supplement that must be satisfactorily addressed before it can be approved.

(mm) Resubmission means a submission by the biologics license applicant or supplement applicant of all materials needed to fully address all deficiencies identified in the complete response letter. A biologics license application or supplement for which FDA issued a complete response letter, but which was withdrawn before approval and later submitted again, is not a resubmission.

[38 FR 32048, Nov. 20, 1973, as amended at 40 FR 31313, July 25, 1975; 55 FR 11014, Mar. 26, 1990; 61 FR 24232, May 14, 1996; 62 FR 39901, July 24, 1997; 64 FR 56449, Oct. 20, 1999; 65 FR 66634, Nov. 7, 2000; 69 FR 18766, Apr. 8, 2004; 70 FR 14982, Mar. 24, 2005; 73 FR 39610, July 10, 2008; 77 FR 26174, May 3, 2012]

Authority: 21 U.S.C. 321, 351, 352, 353, 355, 356c, 356e, 360, 360i, 371, 374, 379k-l; 42 U.S.C. 216, 262, 263, 263a, 264.

-
-