The device was received and the complaint was confirmed as separated rather than fractured.It is unknown if the patient followed post-operative physical restriction or suffered a fall.Examination of the connector found the assembly pin to be smashed, and distorted allowing the rotating connector to pull through the body housing, and disassemble not fracture.All parts seemed to be accounted for; no unretrieved fragments were identified.The root cause is unknown though the damage observed is most likely the result of excessive force exceeding the strength of the pin stop.The patient was noted as a non-union, which can create excessive loading, or maybe the result of excessive physical post operative physical activity, or a fall.No additional investigation can be completed.Labeling review: " [¿ ] potential adverse events and complications potential risks identified with the use of this system, which may require additional surgery, include: bending, fracture or loosening of implant component(s), loss of fixation, nonunion or delayed union [¿]." "[¿] warnings, cautions and precautions: correct selection of the implant is extremely important.The potential for success is increased by the selection of the proper size of the implant.While proper selection can minimize risks, the size and shape of human bones present limitations on the size and strength of implants.Metallic and internal fixation devices cannot withstand the activity levels and/or loads equal to those placed on normal, healthy bone.These devices are not designed to withstand the unsupported stress of full weight or load bearing alone.These devices can break when subjected to the increased load associated with delayed union or nonunion.Internal fixation appliances are load-sharing devices that hold bony structures in alignment until healing occurs.If healing is delayed, or does not occur, the implant may eventually loosen, bend, or break.Loads on the device produced by load bearing and by the patient¿s activity level will dictate the longevity of the implant.Pivoting rod-rod connectors should be used in pairs i.E.Two per side [¿]." " [¿] patient education: preoperative instructions to the patient are essential.The patient should be made aware of the limitations of the implant and potential risks of the surgery.The patient should be instructed to limit postoperative activity, as this will reduce the risk of bent, broken or loose implant components.The patient must be made aware that implant components may bend, break or loosen even though restrictions in activity are followed [¿].".
|
The patient underwent a spinal procedure with reline products on unknown date.In the surgery, the physician installed rods on the l3/4 and attached o-o rotating connectors on the rods.After that, the physician installed another rods on the o-o rotating connectors and jointed to l4/sai with its rods.On (b)(6) 2020, due to a pseudarthrosis (nonunion), the patient underwent a revision surgery in order to re-fix from l3 to sai with single rods.Intraoperatively, when the physician tried to remove the o-o rotating connectors of l3/4, he noticed that the o-o rotating connector on the left side fractured.He removed the broken parts, however, he was not able to find one broken part.He decided to complete the operation without removing it.
|