The user facility reported that the capiox device was used during the procedure.The pediatric membrane oxygenator model w40 - terumo was used in a surgery of a congenital patient, with ebstein's anomaly, at (b)(6).After a period of cardiopulmonary bypass, where it had already been performed a del nido aortic clamping and cardioplegia, it began to leak a "foam" through the quick coupling connector (next to the cava tubes connection).The preparation and prime of the circuit were carried out in the usual way and in accordance with the institution's protocol.During the intercurrence with the afore mentioned material, it was observed that there was a variation in the amount of foam that leaked according to the amount of volume in the venous reservoir, if the volume in the venous reservoir was below the mesh (blood volume filter that arrives from the armholes), the amount of foam coming out was in a smaller amount, as well as the opposite, the greater the amount of volume in the venous reservoir (above the mesh), the greater the amount of foam.It was also observed that if some amount of air came through the venous drainage tubes, the amount of foam also increased.For safety reasons, this connection, through which the foam was leaking, was not obstructed during the entire procedure, with no risk of pressurization in the venous reservoir and, consequently, air return through the venous entrance.This patient did not have any blood disorder or increase in serum albumin and vacuum drainage technique was not used throughout the procedure.The perfusion, like the surgery, took place without compromising the patient.The procedure outcome was not reported.The patient was not harmed.
|
Implanted date: device was not implanted.Explanted date: device was not explanted.Pma/510(k)- k130520.The actual device was not returned; therefore, an evaluation of the actual device was unable to be conducted.Simulation test: from experience, it has been confirmed the phenomenon that air bubbles flowed out from the upper side of the reservoir venous filter by the following mechanism.Air continued to enter the venous line due to blood removal failure or loosening of the yellow cap at the venous blood inlet port.Removed the cap connected to the port (1/4" - 3/8" port) next to the venous blood inlet port.As a mechanism of air bubbles flowing out from the upper side of venous filter when air was mixed from the venous line, it was inferred that the mixed air accumulated as air bubbles in the venous filter.After that, the air bubbles accumulated in the venous filter removed the cap connected to the 1/4 "-3/8" port and overflowed from the 1/4 "-3/8" port.Product structure: a defoamer is attached to the inside of venous filter of the involved product.The air that has flowed into the venous filter is defoamed by the defoamer.A review of the device history record and the product release decision control sheet of the involved product code/lot# combination was conducted with no findings.From experience, it was likely that since air continued to be mixed from the venous line for some reason, bubbles accumulated inside the venous filter, and bubbles overflowed from the upper part of the venous filter.However, with no device return the exact cause of the reported event cannot be definitively determined based on the available information.(b)(4).
|