Model Number AX1000 |
Device Problems
Failure to Align (2522); Contamination of Device Ingredient or Reagent (2901)
|
Patient Problems
No Patient Involvement (2645); No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 08/17/2020 |
Event Type
malfunction
|
Manufacturer Narrative
|
This report has been identified as b.Braun medical inc.Internal report number (b)(4).The device logs and the transfer set have not been received for evaluation.The investigation is currently ongoing.A follow-up will be submitted when the investigation results become available.
|
|
Event Description
|
As per user facility: it was stated that the pump ran fine for the majority of the day.During troubleshooting for occlusions the lines were reprimed and a manifold flush was done.After the sterile water on line 1 was finished pulling for the flush, it was observed that lipids were being pushed through the transfer set tubing.The lipids being used were smof lipid 20% on line 25 (macro) and nutrilipid on line 26 (macro).When the transfer set was removed it was noticed that the valve on the transfer set manifold on line 25 (smof lipid 20%) was stuck in an open position.There were visible markings on the valve that were indicative of an attempt to close but failed to do so.There was no patient involvement.
|
|
Manufacturer Narrative
|
This report has been identified as b.Braun medical inc.Internal report number (b)(4).One (1) used transfer set was returned for evaluation.Visual examination of the set noted that valve 25 was in an open position.The sample was leak tested per specification and it was noted that air was coming from the end of line 25.It was determined this issue is not a manufacturing defect.The device logs were reviewed and showed the transfer set ran normally for most of the day (about 7 hours) with normal dispenses from all stations including station 25.Pressure values for station 25 were normal and typical throughout the day as well.During the final dispense of fluid from station 25, the valve attempted to close and caused the manifold to become unlatched.The sensor values were immediately impacted which triggered an alert to the user and the apex stopped.The transfer set was removed and station 25 was in an open state.It is possible the user may have improperly latched the manifold onto the compounder and while compounding, the manifold became detached and halted compounding.A retained transfer set was visually inspected and no defects were noted.The retained transfer set was occlusion tested and vacuum leak tested per specification with passing results.Review of the discrepancy management system database performed for the reported lot number did not reveal any abnormalities or non-conformances of this nature.If additional pertinent information becomes available a follow-up report will be filed.
|
|
Search Alerts/Recalls
|