Model Number 0684-00-0296-01 |
Device Problem
Difficult to Remove (1528)
|
Patient Problem
Injury (2348)
|
Event Date 09/10/2020 |
Event Type
Injury
|
Manufacturer Narrative
|
Complete initial reporter name: (b)(6).The device has not been returned to the manufacturer so we are unable to complete an evaluation.If provided we will send a supplemental report with our additional findings.Complaint record id # (b)(4).
|
|
Event Description
|
It was reported that after the intra-aortic balloon (iab) leak and blood was seen in the helium tubing, the console was put on standby for 1.5 hours and the patient was heparinized before the iab was removed.Once the iab was being removed, it became stuck and needed to be removed surgically.This incident is caused by user, since they did not follow the instructions for use.
|
|
Manufacturer Narrative
|
The product has been returned to the manufacturer, but is pending investigation.Once the investigation is completed a supplemental report with our findings will be submitted.Complaint # (b)(4).
|
|
Event Description
|
It was reported that after the intra-aortic balloon (iab) leak and blood was seen in the helium tubing, the console was put on standby for 1.5 hours and the patient was heparinized before the iab was removed.Once the iab was being removed, it became stuck and needed to be removed surgically.This incident is caused by user, since they did not follow the instructions for use.
|
|
Manufacturer Narrative
|
The product was returned with the membrane completely unfolded with blood on the exterior and interior of the catheter and between the catheter and the returned maquet sheath.The catheter tubing was flat/deformed near the y-fitting at approximately 74.7cm from the iab tip.An underwater leak test of the balloon, y-fitting, catheter tubing and extracorporeal tubing was performed and a leak was detected from a tear on the membrane approximately 2cm from the rear seal and measuring 0.8cm in length.The tear found appeared to had been caused by a sharp object.However, we were unable to confirm the reported difficulty removing the iab from the patient due to the returned condition of the catheter.We were unable to duplicate the clinical settings.A device and lot history record review was completed for the reported product.No nonconformances were found that are considered to be related to the event.The failure mode is addressed in the risk file and is operating within its risk profile.The ifu addresses the reported failure.There were no ncmrs identified which could cause or contribute to the reported failure.The investigation does not indicate that the device was inadvertently released as non-conforming or an adulterated product or was a counterfeit.The complaint history review did not identify an adverse trend (increase in number of complaints over past three (3) months).Based on the rational provided above, no escalation to the capa process is required.Reference complaint# (b)(4).
|
|
Event Description
|
It was reported that after the intra-aortic balloon (iab) leak and blood was seen in the helium tubing, the console was put on standby for 1.5 hours and the patient was heparinized before the iab was removed.Once the iab was being removed, it became stuck and needed to be removed surgically.This incident is caused by user, since they did not follow the instructions for use.
|
|
Search Alerts/Recalls
|