|
Model Number 2200-2515 |
Device Problems
Inflation Problem (1310); Material Rupture (1546)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 09/14/2022 |
Event Type
malfunction
|
Event Description
|
The angiosculpt device was used for pre-dilation on a calcified mid lad.After advancing the angiosculpt to the lesion, the balloon was inflated to nominal pressure (8 atm) but did not inflate as expected under fluoroscopy.Upon removal of the angiosculpt, a balloon rupture was observed.The procedure was completed with a non-angiosculpt device.No patient injury reported.This product problem is being submitted conservatively because the balloon ruptured below rbp.
|
|
Manufacturer Narrative
|
The patient''s dob or age at time of event, gender, weight, ethnicity, and race are unknown.This information was not available from the facility.Patient information regarding relevant tests/laboratory data or medical history are unknown.This information was not available from the facility.Foreign source: hong kong.The angiosculpt device was returned for evaluation; however, the device evaluation has not yet begun, thus a supplemental report will be filed upon completion.Submission of this report does not, in itself, represent a conclusion by the manufacturer and/or authorized representative or the national competent authority that the content of this report is complete or accurate, that the medical device(s) listed failed in any manner and/or that the medical device(s) caused or contributed to an alleged death or deterioration in the state of the health of any person.
|
|
Manufacturer Narrative
|
Block h3: the angiosculpt device was returned for evaluation.Visual inspection found no unusual characteristics of the device.During functional testing, using an indeflator filled with green color dye water, the device was pressurized to nominal (8 atm) and a leak was observed at the distal tip.No balloon rupture was detected.Block h6: a balloon rupture could not be confirmed.However, a leak was observed at the distal tip caused by a damaged inner lumen.All units are 100% leak tested during the manufacturing build; therefore, it is likely the inner lumen was damaged during use when backloading the guide wire.Additionally, medical device problem code was corrected from 1546 (material rupture) to 1310 (inflation problem).Submission of this report does not, in itself, represent a conclusion by the manufacturer and/or authorized representative or the national competent authority that the content of this report is complete or accurate, that the medical device(s) listed failed in any manner and/or that the medical device(s) caused or contributed to an alleged death or deterioration in the state of the health of any person.
|
|
Search Alerts/Recalls
|
|
|