|
Catalog Number EMAX2PLUS |
Device Problems
Break (1069); Unintended System Motion (1430); Device-Device Incompatibility (2919); Noise, Audible (3273); Excessive Heating (4030)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 01/01/2023 |
Event Type
malfunction
|
Manufacturer Narrative
|
This report is being submitted pursuant to the provisions of 21 cfr, part 803.This report may be based on information which has not been investigated or verified prior to the required reporting date.This report does not reflect a conclusion by depuy synthes, or its employees that the report constitutes an admission that the product, depuy synthes, or its employees caused or contributed to the potential event described in this report.Device was used for treatment, not diagnosis.If information is obtained that was not available for this medwatch, a supplemental medwatch report will be filed as appropriate.H10 additional narrative: device evaluation: the actual device was returned for evaluation.During repair, it was determined that the reported condition that the device knurled knob did not lock was not confirmed.Therefore, an assignable root cause was not determined.However, during evaluation, it was determined that the failures identified during service and repair have been confirmed.The assignable root cause was determined to be due to component failure from wear.Udi: (b)(4).
|
|
Event Description
|
It was reported by switzerland that during service and evaluation, it was determined that the motor device produced heat, had insufficient/low power, leaked air, produced excessive noise, unintended activation/motion, could not remove cutter, could not secure/lock cutter and had cord damage.It was further determined that the device failed pretest for visual assessment, loctite assessment, safety assessment, rotational speed assessment, rotational speed assessment, noise assessment, air pump assessment, handpiece temperature assessment, hand control assessment and cutter lock assessment.It was noted in the service order that the device had a lever lock defect(knurled knob would not lock) and the motor was noisy.This event did not occur during surgery.There was no patient involvement.There were no reports of injuries, medical intervention or prolonged hospitalization.The exact date of the event was unknown.However, it was reported that the event occurred in 2023.All available information has been disclosed.If additional information should available, a supplemental medwatch will be submitted accordingly.
|
|
Search Alerts/Recalls
|
|
|