On (b)(6) 2024, a medical device and its associated components used in the delivery of a permanent radioactive source implant to the prostate did not perform as expected.The prostate seed implant is delivered under sterile conditions in an operating room.The medical device, a radioactive seed about the size of a grain of rice, is shipped to clinics in a pre-loaded cartridge that feeds the seeds into a channel for dispensing, like a magazine.In this instance, the seeds from several cartridges would not dispense.To complete the prescribed treatment, the seeds were manually ejected by the operating personnel from the cartridges, and the loose seeds were used instead.The patient received the planned implant with the malfunction causing about a 30-min delay in the procedure.Immediately after the procedure, an email was sent to the manufacturer, bard, notifying them of the malfunction and to file a complaint.The next day, a representative picked up the empty cartridges for their investigation.On (b)(6), the same representative reported that the malfunction was traced back to the mislabeling of cartridges and gathered some details to send replacement orders for upcoming patient cases.The manufacturer has not yet released a formal report on this event.The event on (b)(6) comes after a period of other minor events that have been reported to the manufacturer involving their equipment.In one example that occurred on (b)(6) 2024, we reported that two cartridges in a patient's seed order had the incorrect number of seeds in them.Cartridges were ordered to have (b)(4) seeds in them but instead had (b)(4), respectively.Since radioactive material must be always accounted for, the error in the cartridge loading created the appearance of a lost seed initially and significant resources were spent to locate it.Later the missing seed was accounted for in the cartridge that was supposed to have (b)(4) as it contained (b)(4).We have experienced other events, including issues with dispensing seeds or seeds jamming in the associated equipment.These events have been reported internally and to the manufacturer.Most of these events are still under investigation by the manufacturer.We are concerned with the quality control of the manufacturer.Reference reports mw5152696, mw5152697, mw5152698.
|