Model Number 3773MM |
Device Problem
Infusion or Flow Problem (2964)
|
Patient Problem
No Known Impact Or Consequence To Patient (2692)
|
Event Type
malfunction
|
Event Description
|
The complainant reports the opti-mist plus nebulizer does not nebulize medication.
|
|
Manufacturer Narrative
|
Based on the available information, this event is deemed a reportable malfunction.No further information was available at the time of the report.Additional patient/event details have been requested.There were no reports of the patient being harmed as a result of this malfunction.Should additional information become available, a follow-up report will be submitted.This complaint involves an estimate quantity of 75 devices but, the exact quantity is unknown and could not be confirmed by the complainant.
|
|
Manufacturer Narrative
|
A quality complaint investigation was performed.Two used samples were returned to assist with the investigation.The investigation performed by quality department of the manufacturing site indicated that product failed to meet the minimum aerosol out put (1.5 ml) requirement specified in convatec test procedure.A previous investigation is applicable to this complaint investigation and will be leveraged.This previous investigation is open.Therefore, this complaint will remain open until completion of the previous investigations.No additional patient/event details have been provided to date.Should additional information become available a follow-up report will be submitted.
|
|
Manufacturer Narrative
|
Additional information was received on 07/20/2015.Returned product was received at the manufacturing site.Updated (device available for evaluation).Evaluation is still in progress.No additional patient/event details have been provided to date.Should additional information become available a follow-up report will be submitted.Reported to the fda on 07/27/2015.
|
|
Manufacturer Narrative
|
Previous investigation has been closed.Two root causes were identified.The jet was being produced in an old injection molding machine that was not conditioned with an alarm to detect and prevent the variation (double cycle) in the process.This machine has been discontinued.Inadequate inspection process for nebulizers.Corrective action has been implemented to include: verifying all active molding machines to confirm all have integrated the required alarms.Create a temporary quality alert to inspect nebulizer components every 2 hours as our inspection process is updated.Creation of a test method for inspection of molded components (nebulizer set and jet).Create a test method for inspection of molded components, clarify all details of process to do the mixing and add a form to record the amount of resin and material used in each mixing, determine water flow rates, water temperature and pressure, and include process parameters to be monitored.Determined the expected shelf life of pins for the orifice of cup and jet, and establish its replacement in the adequate period of time.No additional patient/event details have been provided to date.Should additional information become available a follow-up report will be submitted.Reported to the fda on december 28, 2015.(b)(4).
|
|
Search Alerts/Recalls
|