|
Catalog Number 319.006 |
Device Problem
Failure to Align (2522)
|
Patient Problem
No Known Impact Or Consequence To Patient (2692)
|
Event Date 11/04/2016 |
Event Type
malfunction
|
Manufacturer Narrative
|
Device is an instrument and is not implanted / explanted.No service history review can be performed as part number 319.006 with lot numbers 9874111 is a lot/batch controlled item.The lot/serial number cannot be traced.The manufacture date is unknown.The service history review is unconfirmed.Device history records review was completed for part # 319.006, lot # 9874111.Release to warehouse date: aug 26, 2015, made by synthes (b)(4).No non conformance reports were generated during production.Review of the device history records showed that there were no issues during the manufacture of the product that would contribute to this complaint condition.The device was received and the product evaluation is in progress.No conclusion can be drawn.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
|
Event Description
|
It was reported that on (b)(6) 2016, during a distal phalanx open reduction internal fixation (orif), two depth gauges were not sliding back and forth smoothly.There was a less than one minute delay in surgery to switch depth gauges.The patient outcome was reported as stable.This report is for one (1) depth gauge for 2.0mm and 2.4mm screws.This is report 2 of 2 for (b)(4).
|
|
Manufacturer Narrative
|
Service and repair evaluation was completed for part # 319.006, lot # 9874111.The customer reported the depth gauge was not sliding back and forth smoothly.The repair technician reported the device did not operate smoothly, and was sticking and binding.Binding is the reason for repair.The item is not repairable per the inspection sheet.The cause of the issue is unknown.The item was forwarded to customer quality.The evaluation was confirmed.Product investigation was completed.A visual inspection, drawing review and device history records review were performed as part of this investigation.The complaint is confirmed.The returned device is very difficult to slide back and forth.There are scratches on the slider body which appear to be a result of interaction with the sleeve.There is some minor surface wear on the device which does not impact functionality.The 319.006 depth gauge is part of at least 14 technique guides, including the 2.4 mm variable angle lcp distal radius system and is used to measure the depth of the holes for the 2.0mm/2.4mm screws to ensure the correct screw length is used during the procedure.The information is provided per the 2.4 mm variable angle lcp distal radius system technique guide.Drawings were reviewed.The width of the slider for 319.006 was measured to be 7.85mm which is within the specification of 7.85mm +/- 0.05.The height of the slider for 319.006 was measured to be 5.78mm which is within the specification of 5.8mm +0.0/- 0.05.The inner diameter of the body for 319.006 was measured to be 8.0mm which is within the specification of 8.0mm + 0.05/-0.0.Measured using mitutoyo caliper.There were no issues during the manufacture of this product that would contribute to this complaint condition.The design history was not found to impact the complaint condition.During the investigation no product design issues or discrepancies were observed that may have contributed to the complaint condition.The returned parts were determined to be suitable for the intended use when employed.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
|
Search Alerts/Recalls
|
|
|