Reporter is a synthes employee.The device was received, the investigation is in progress, no conclusion could be drawn at the time of filing this report.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
Depuy synthes is submitting this report pursuant to the provisions of 21 cfr, part 803.This report may be based on information which depuy synthes has not been able to investigate or verify prior to the required reporting date.This report does not reflect a conclusion by fda, depuy synthes or its employees that the report constitutes an admission that the device, depuy synthes, or its employees caused or contributed to the potential event described in this report.A product investigation was conducted.Visual inspection: up on visual inspection, the needle was found to be slight bent.The device was not missing any hook as the needle/depth probe is not suppose to have any hook per drawing se_408424 rev c.There is nothing found missing or broken off the device.Hence, the reported condition is not confirmed.Dimension inspection: the diameter of the needle was measured and is within specification per relevant drawing.Investigation conclusion: the exact cause of the bent condition is unknown, but, it is likely that the device experienced excessive force during uses.During the investigation no unidentified product design/manufacturing issues or discrepancies were observed that may have contributed to the complaint condition.Based on the investigation findings, it has been determined that no corrective and/or preventative action is proposed.Additional monitoring for any potential safety signals will be conducted through complaint trending and other post market safety surveillance activities.A device history record (dhr) review was conducted: part number: 03.019.029.Lot number: 8310950.Manufacturing site: hägendorf.Release to warehouse date: 21.Feb.2013.A manufacturing record evaluation was performed for the finished device lot number, and no non-conformances were identified.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|