The sensor on the arterial line failed, and it did not show the flow nor the bubbels, therefore the machine was switched, the patient died after a few days.Adverse event awareness date: (b)(6) 2020.Complaint id: (b)(6).
|
It was reported that the flow/bubble sensor was not working.The device history record (dhr) of the cardiohelp (material: 701048012, serial: (b)(6)) for which a customer complaint was received, was reviewed on (b)(6) 2020.The dhr does not show any abnormality or issue that is related or can have led to the customer complaint.The cardiohelp was investigated by getinge life cycle engineering under lce4452 on (b)(6) 2021.It was determined that the flowdigiboard was defective.At the time of failure, the arterial bubble interventions were activated.Every bubble alarm causes the pump to stop.Due to the defective flowdigiboard the bubble alarm was permanently triggered and thus the bubble alarm cannot be reset.The root cause for the reported failure is a defective flowdigiboard.For further investigation a medical review was performed on (b)(6) 2021.After the pump stopped because of the failed flowdigiboard, the user tried to reset the arterial bubble detection three times in a time frame of 11 seconds.Then the user switched the arterial bubble sensor intervention off and the pump started to run.The total time of the pump stop was 54 seconds.During the event the user adjusted the ventilation from protective to more invasive ventilation.The patients¿ oxygen saturation declined from 87% to 74%, there was no change in the circulation and no other problem occurred.The patient died a view days after the event.According to the users statement the patients death was not a consequence of the pump stop.
|