|
Model Number C146F7 |
Device Problem
Device Contamination with Chemical or Other Material (2944)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 11/12/2021 |
Event Type
malfunction
|
Event Description
|
It was reported that there is some type of a metal piece on this catheter close to the the proximal port that is coming off.This short piece of metal became dislodged and was moving under fluoro.The catheter was then removed and cut open, and the same type of wire material was removed.There is no patient injury reported.
|
|
Manufacturer Narrative
|
The device evaluation is anticipated.However, the complaint cannot not be confirmed without the completion of a product evaluation.A supplemental report will be forthcoming with the evaluation when it is available.The udi number for this device is: (b)(4).
|
|
Manufacturer Narrative
|
One c146f7 with monoject limited volume syringe was recieved for evaluation.Catheter body was received in three pieces with a black rod.Catheter was cut at 29cm and 30cm from catheter tip.The reported event of component coming off was unable to be confirmed.Per description of event, "the catheter was then removed and cut open, and the same type of wire material was removed." as received, catheter was cut at 29cm and 30cm from catheter tip and unknown black marker closed to the proximal port was also returned.The edges at the cuts appeared to match.The findings were aligned to customer photo.Per drawing 670674 rev.Al, rod-tantalum was used to plug proximal lumen at the lumen port.Adhesive material was visible on the rod.However, further evaluation regarding manufacturing non conformance will be conducted.A device history record review was completed and documented that device met all specifications upon distribution.Complaint histories for all reported events are reviewed against trending control limits on a monthly basis and any excursions above the control limits are assessed and documented as a part of the monthly review.
|
|
Manufacturer Narrative
|
The product evaluation could not confirm since the catheter was returned cut at 29cm and 30cm.As per the image and the evaluation provided, the piece of metal is the "rod tantalum" (in: 400896004) that is part of the manufacturing process and is inserted inside the proximal injectate port.Since the device was returned cut, the allegation was unable to be confirmed.However, adhesive is applied to the plug (rod tantalum - in: 400896004), and then it is inserted from the wetted side towards the distal side of the proximal slot.The plug must be flush with the edge of the slot.There are multiple procedures in place to ensure that the plug is snug and not protruding the space.Then a second coat of adhesive is applied over the plug.The location is verified that the slot area does not have excess adhesive and that it does not cover the proximal part of the tube; and finally, it is verified that the "tantalum rods" in the npvc product remain in position.Based on the procedures, if the unit had a defect as rod tantalum detached or any cut, it would have been capture during these inspection processes.Complaint histories for all reported events are reviewed against trending control limits on a monthly basis and any excursions above the control limits are assessed and documented as a part of the monthly review.
|
|
Search Alerts/Recalls
|
|
|