It was reported that the stent would not deploy.As a result of analysis of returned device, the outer sheath was detached and stent was partially deployed.There was kinking on the stent loaded part of the outer sheath, and deployment was tried without pressure, and very strong resistance occurred, but it was gradually deployed, resulting in deployment success.In the inner sheath, kinking was observed in the same position.It was confirmed from the device history record that device had been manufactured with no significant issues and passed all the inspections successfully.Resistance can be felt due to pressure generated by patient's lesion during deployment.It can cause deployment failure if deployment is tried by force in this situation since outer sheath can be stretched and detached.However, it is hard to identify the exact root cause since it is hard to reconstruct the situation at the time of procedure.Based on the deployment success under no pressure even though the strong resistance has occurred, detached outer sheath and kinking on the stent loaded part, it is considered that delivery system was pressured due to patient's lesion during the procedure and deployment was tried in that situation.It was hard to deploy due to pressure, in which concentrated the force, and causing kinking to occur.Therefore, it seems that strong resistance occurred and the outer sheath was detached in the end, resulting in deployment failure.This complaint is assumed that it was a malfunction of the device due to the pressure of the patient's lesion, there will be continued monitoring of the same or similar customer complaints.
|
After the device was prepped, and it was placed down the scope, the stent would not deploy.Therefore, the physician removed the complaint device and opened a new stent (unknown make and model) to complete the intended procedure successfully.
|