BIOSENSE WEBSTER, INC. (JUAREZ) LASSO® 2515 NAV ECO VARIABLE CATHETER; CATHETER, ELECTRODE RECORDING OR PROBE, ELECTRODE RECORDING
|
Back to Search Results |
|
Model Number D-1343-02-S |
Device Problems
Detachment Of Device Component (1104); Difficult To Position (1467)
|
Patient Problem
No Known Impact Or Consequence To Patient (2692)
|
Event Date 11/26/2014 |
Event Type
malfunction
|
Event Description
|
It was reported that a patient underwent a procedure with a lasso navigational variable eco catheter and during the bwi failure analysis lab investigation of the returned catheter, it was found that the puller wire was out of the pulley mechanism and that this may affect the deflection to be stuck.It was reported initially, that during the bend test before introduction into the patient, the catheter did not bend on any action of the piston on the curvature.The pulling cable appeared to be broken inside the catheter.The replacement of the catheter resolved the issue.The procedure was completed with no patient consequences.It was assessed as not reportable as the most likely consequence was an intraprocedural delay.The potential risk that it could cause or contribute to a serious injury or death is remote.This event is being reported because the bwi failure analysis lab received the device for evaluation and found during the investigation, the puller wire was out of the pulley mechanism.After further review, this finding was assessed as a reportable issue on (b)(6) 2015 as this failure may affect the deflection to be stuck.The awareness date for this record is (b)(6) 2015.
|
|
Manufacturer Narrative
|
The bwi failure analysis lab received the device for evaluation.The analysis has begun but is not completed at this time.When the investigational analysis has been completed, a supplemental 3500a report will be submitted.(b)(4).
|
|
Manufacturer Narrative
|
(b)(4).It was reported that a patient underwent a procedure with a lasso navigational variable eco catheter.During the bend test before introduction into the patient, the catheter did not bend on any action of the piston on the curvature.The pulling cable appeared to be broken inside the catheter.The replacement of the catheter resolved the issue.The procedure was completed with no patient consequences.Upon receiving, the catheter was visually inspected and it was found partially deflected.The piston that controls the deflection mechanism of the catheter was activated and it was unable to move.The catheter was tested for deflection and the catheter failed.Then the catheter was dissected and it was found that the deflection puller wire came off the pulley and was stuck between the block and the pulley causing the catheter to get stuck in a deflected position.The device history record (dhr) was reviewed; the dhr review verifies that the device was manufactured in accordance with documented specification and procedures.The customer complaint has been verified.
|
|
Search Alerts/Recalls
|
|
|