Catalog Number 03.010.072 |
Device Problem
Bent (1059)
|
Patient Problem
No Known Impact Or Consequence To Patient (2692)
|
Event Date 12/06/2015 |
Event Type
malfunction
|
Manufacturer Narrative
|
Device is an instrument and is not implanted/explanted.Complainant part is expected to be returned for manufacturer review/investigation, but has yet to be received.Manufacturing location: (b)(4).Manufacturing date: 22february2006.No non-conformance reports were generated during production.Review of the device history record(s) showed that there were no issues during the manufacture of the product that would contribute to this complaint condition.The investigation could not be completed; no conclusion could be drawn, as no product was received.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
|
Event Description
|
It was reported that during an open reduction internal fixation of the tibia, performed on (b)(6) 2015, the surgeon was having a difficult time hooking the two depth gauges to the bone to get a measurement.The devices were worn and were noted to be badly bent.Subsequently the case was delayed but successfully completed using the bent devices.This is report 2 of 2 for (b)(4).
|
|
Manufacturer Narrative
|
Device was used for treatment, not diagnosis if information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
|
Manufacturer Narrative
|
Additional narrative: product investigation summary: the following device(s) were received: depth gauge for locking screws (part 03.010.072 / lot 1457051).Depth gauge for locking screws (part 03.010.072 / lot 1476682).The devices were returned with minimal cosmetic damage that is consistent with their 9+ years of use.The distal hooked tips of both devices are bent and wavy.The damage does not appear to be the result of normal use.Rather, it appears to be the result of damage during cleaning/sterilization when in a disassembled state.But the exact cause of the deformation could not be determined.A visual inspection, functional test, and drawing review were performed as part of this investigation.No product design issues or discrepancies were observed.This complaint is confirmed.The returned instrument(s) are used during femoral and tibial nail implantations and proper use and maintenance are addressed in technique guides.The returned device is multi use and is used for determining the length of locking screw during implantation of intramedullary nails.The complaint condition was most likely due to rough handling in sterile processing and wear/tear over the life of the instrument, rather than the design of the instrument.The relevant drawing for the device(s) was reviewed.No drawing issues or discrepancies were noted.The design is adequate for its intended use and did not contribute to this complaint condition.No manufacturing or design issues were noted during the investigation.The design is determined to be adequate for its intended use when used and maintained as recommended.Device used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
|
Search Alerts/Recalls
|