This complaint is part of internal retrospective review of complaints received from march 2014 to march 2016, conducted by oscor as a result of process improvements made to the complaint system to ensure proper medical device reporting is maintained.As part of the detailed review, this event has been determined to be reportable.This initial mdr is being submitted to meet our requirements of reporting.The cable was not returned for analysis.A review of the device history record (dhr) could not be performed as the lot number of the cable was not provided.As the device was not returned, however, the cause of the cable failure is determined to be a weak cable-to-connector solder joint.The potential cause of this failure may be: insufficient strength of soldering and crimping of connectors to the cable wire.The potential effect to the user/device may be: disruption of the cable function.A corrective and preventive action has been opened to address this failure.Oscor will continue to monitor this device for complaint trends and risk.Review of the atar mdts cable inspection procedure identified that inspection of the following is done per 100%: each strand of the cable is checked for the correct colored part, cable is measured and verified for overall length, cable is checked for damage and insulation voids, the inspector verifies that the silicone strain relief extends at least for a length of 2 cm outside the female connector, the silicone strain relief is checked so that it fits the wire snugly, strain relieves are checked for damage and gaps, and pull test to verify strength of soldered joint.The cable is also 100% inspected for continuity and for proper connector function.The instructions for use (ifu) informs the user that the cable can be re-sterilized by oscor eto gas sterilization a maximum of two times.Precautions are provided to the user: do not connect any cable model to a/c power source; connection of exposed pins to a/c power source may pose a risk of serious injury or death.
|