No information was provided from the reporting site as to the patient.No injury was reported.Only that the product did not function correctly.The information was received from a distributor of the product in (b)(6).However the initial reporter was the hospital but no e-mail address was provided only the name of the reporter.The following is information concerning the distributor.(b)(4).3m provided notification to fda of their recall.Fda acknowledged our submittal on october 18, 2017 via email but has not yet provided any other reference information.Recall has been initiated by 3m on october 17, 2017 for the following lots and applicable expiration dates.The classification of the recall is considered a class ii.The letters were reviewed by fda.Lot : expiration date : 17230 , 2020 aug 18; 17233 , 2020 aug 21 ; 17234 , 2020 aug 22 ; 17241 , 2020 aug 29.The following root cause was reported to fda: root cause for eeprom's programmed with '00000000' in any of the coefficient fields is due to the steinhart-hart equation calculating a valid negative coefficient and then converting the decimal value to hex.In hex, negative numbers are treated differently (since the "-" sign is not valid), so the conversion appends different values to denote a negative number.This format is not transferrable from m17 to eeprom, so 00000000's are placed in the coefficient field.When m17 reviews the data on the eeprom and compares it to m17's database, it sees the '00000000' field and thinks it's correct, thereby passing the circuit to the next phase of assembly.The corrective actions to remedy this problem include: modify the end of line functional test fixture to review the eeprom on a probe and verify that none of the coefficient values are "00000000'.If "00000000' is detected, the fixture will reject the circuit.A 2nd bhtms hardware unit will also be added to check for error codes that cannot be caught by the current end of line functional test fixture.Prior to assembly, a manufacturing engineer will review the sql database for each panel to identify bad sensors.A barcode scanner will be added to the assembly line that will be used by the operators to scan every sensor panel barcode and cross reference with a list of negative coefficients, supplied by an engineer.Note: the above corrective actions are in place and have been verified as of october 9, 2017.The date 3m became aware of the defect was on september 17, 2017.End of report.
|