Model Number APTIO AUTOMATION |
Device Problem
Electrical /Electronic Property Problem (1198)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 10/13/2021 |
Event Type
malfunction
|
Manufacturer Narrative
|
The siemens customer service engineer (cse) performed service repairs on the aptio automation system and observed the issue while troubleshooting robot configuration errors.The cse confirmed that all covers were secured and replaced the motor driver board.Siemens noted that the issue remained and performed additional services, including installing a new motor driver and replacing the tilting tube assembly.The cse reprogramed the stepper motor driver board, downloaded drivers, and installed firmware.The system was verified, and the module was operational.Siemens monitored the system's operation for a few days and identified the motor's temperature was normal.The cse noted no other issue.Siemens is investigating the event.
|
|
Event Description
|
Siemens was informed that a motor was overheating on an aptio automation system by siemens.A customer service engineer (cse) was onsite to service the system and identified the aliquoter module tube tilter motor was hot and disconnected power to the motor.There are no reports of patient intervention or adverse health consequences due to the motor overheating.
|
|
Manufacturer Narrative
|
Siemens filed the initial mdr 22517506-2021-00311 on 03-nov-2021.Additional information (05-nov-2021): siemens reviewed the information and determined that the robot arm stepper motor driver that was used on-site included the wrong configuration and caused the stepper motor to overheat.Siemens determined the pre-programmed driver board comes pre-installed with the configuration for a new style motor and was not directly compatible with the older version of the motor that was installed on the system.Siemens concluded the system required an unprogrammed driver board to load the compatible program and identified no issue with the stepper motor.The aptio automation system by siemens is operating as intended, and no further evaluation of the system was required.Siemens updated section h6 (investigation conclusions) to include a new code.
|
|
Search Alerts/Recalls
|