MAUDE Adverse Event Report: MEDTRONIC NAVIGATION, INC (LITTLETON) O-ARM 1000 IMAGING SYSTEM 3RD EDITION; IMAGE-INTENSIFIED FLUOROSCOPIC X-RAY SYSTEM, M

Model Number BI70000028120

Device Problem Unexpected Shutdown (4019)

Patient Problem No Clinical Signs, Symptoms or Conditions (4582)

Event Date 12/03/2021

Event Type  malfunction  

Event Description

Medtronic received information regarding an imaging system being used outside of a procedure.It was reported that after a case, when moving the system the manufacturer representative stated that if the key on the image acquisition system (ias) was touched they would hear relays clicking in the system, leds would flash, and the ias started powering down.There was no patient involvement.

Manufacturer Narrative

Concomitant medical products : information references the main component of the system.Other relevant device(s) are: product id: b i71000741 product id: bi70000053 product id: bi70000052 product id: bi71000489 product id: bi71000645.A medtronic representative went to the site to perform a system checkout.The complaint was confirmed.The key switch, system control board, and power switching board were replaced.Fdm b01, fdr c02, fdc d02 are applicable to the system checkout.If information is provided in the future, a supplemental report will be issued.

Manufacturer Narrative

H3: a hardware analysis of (b)(6) was initiated to determine the probable cause of the issue.Analysis found no failure and was unable to confirm reported complain.Medtronic is submitting this report to comply with fda reporting regulations under 21 cfr parts 4 and 803.This report is based upon information obtained by medtronic, which the company may not have been able to fully investigate or verify prior to the date the report was required by the fda.Medtronic has made reasonable efforts to obtain more complete information and has provided as much relevant information as is available to the company as of the submission date of this report.This report does not constitute an admission or a conclusion by fda, medtronic, or its employees that the device, medtronic, or its employee caused or contributed to the event described in the report.In particular, this report does not constitute an admission by anyone that the product described in this report has any ¿defects¿ or has ¿malfunctioned¿.These words are included in the fda 3500a form and are fixed items for selection created by the fda to categorize the type of event solely for the purpose of regulatory reporting.Medtronic objects to the use of these words and others like them because of the lack of definition and the connotations implied by these terms.This statement should be included with any information or report disclosed to the public under the freedom of information act.Any required fields that are unpopulated are blank because the information is currently unknown or unavailable.A good faith effort will be made to obtain the applicable information relevant to the report.If information is provided in the future, a supplemental report will be issued.

Manufacturer Narrative

H3: the kit svc bi71000489 pcba sys cntrl assy was returned for hardware analysis.The issue could not be confirmed.The system control board was installed in a test system.The test system did not fully initialize, failing system testing.H6: b01, c02, d02 apply to the hardware analysis.Medtronic is submitting this report to comply with fda reporting regulations under 21 cfr parts 4 and 803.This report is based upon information obtained by medtronic, which the company may not have been able to fully investigate or verify prior to the date the report was required by the fda.Medtronic has made reasonable efforts to obtain more complete information and has provided as much relevant information as is available to the company as of the submission date of this report.This report does not constitute an admission or a conclusion by fda, medtronic, or its employees that the device, medtronic, or its employee caused or contributed to the event described in the report.In particular, this report does not constitute an admission by anyone that the product described in this report has any ¿defects¿ or has ¿malfunctioned¿.These words are included in the fda 3500a form and are fixed items for selection created by the fda to categorize the type of event solely for the purpose of regulatory reporting.Medtronic objects to the use of these words and others like them because of the lack of definition and the connotations implied by these terms.This statement should be included with any information or report disclosed to the public under the freedom of information act.Any required fields that are unpopulated are blank because the information is currently unknown or unavailable.A good faith effort will be made to obtain the applicable information relevant to the report.If information is provided in the future, a supplemental report will be issued.

Manufacturer Narrative

H3: a hardware analysis of bi70000053 was initiated to determine the probable cause of the issue.Analysis found no failure and was unable to confirm reported complain.Codes b01, c19, d14 are applicable to this analysis.Medtronic is submitting this report to comply with fda reporting regulations under 21 cfr parts 4 and 803.This report is based upon information obtained by medtronic, which the company may not have been able to fully investigate or verify prior to the date the report was required by the fda.Medtronic has made reasonable efforts to obtain more complete information and has provided as much relevant information as is available to the company as of the submission date of this report.This report does not constitute an admission or a conclusion by fda, medtronic, or its employees that the device, medtronic, or its employee caused or contributed to the event described in the report.In particular, this report does not constitute an admission by anyone that the product described in this report has any ¿defects¿ or has ¿malfunctioned¿.These words are included in the fda 3500a form and are fixed items for selection created by the fda to categorize the type of event solely for the purpose of regulatory reporting.Medtronic objects to the use of these words and others like them because of the lack of definition and the connotations implied by these terms.This statement should be included with any information or report disclosed to the public under the freedom of information act.Any required fields that are unpopulated are blank because the information is currently unknown or unavailable.A good faith effort will be made to obtain the applicable information relevant to the report.If information is provided in the future, a supplemental report will be issued.

• Brand Name: O-ARM 1000 IMAGING SYSTEM 3RD EDITION
• Type of Device: IMAGE-INTENSIFIED FLUOROSCOPIC X-RAY SYSTEM, M
• Manufacturer (Section D): MEDTRONIC NAVIGATION, INC (LITTLETON); 300 foster st; littleton MA 01460
• Manufacturer (Section G): MEDTRONIC NAVIGATION, INC (LITTLETON); 300 foster st; littleton MA 01460
• Manufacturer Contact: glen belmer ; 7000 central avenue ne rcw215; minneapolis, MN 55432 ; 6122713209
• MDR Report Key: 13044484
• MDR Text Key: 284641652
• Report Number: 3004785967-2021-01394
• Device Sequence Number: 1
• Product Code: OXO
• UDI-Device Identifier: 00643169353428
• UDI-Public: 00643169353428
• Combination Product (y/n): N
• Reporter Country Code: US
• PMA/PMN Number: K092564
• Number of Events Reported: 1
• Summary Report (Y/N): N
• Report Source: Manufacturer
• Source Type: Company Representative
• Reporter Occupation: Non-Healthcare Professional
• Type of Report: Initial,Followup,Followup,Followup
• Report Date: 04/07/2022

1 Device was Involved in the Event

1 Patient was Involved in the Event

• Is this an Adverse Event Report?: No
• Is this a Product Problem Report?: Yes
• Device Operator: Health Professional
• Device Model Number: BI70000028120
• Device Catalogue Number: BI70000028120
• Was Device Available for Evaluation?: Device Returned to Manufacturer
• Date Returned to Manufacturer: 12/28/2021
• Initial Date Manufacturer Received: 12/03/2021
• Initial Date FDA Received: 12/20/2021
• Supplement Dates Manufacturer Received: 02/03/2022; 03/22/2022; 03/29/2022
• Supplement Dates FDA Received: 02/24/2022; 03/24/2022; 04/07/2022
• Was Device Evaluated by Manufacturer?: Yes
• Date Device Manufactured: 11/22/2014
• Is the Device Single Use?: No
• Is This a Reprocessed and Reused Single-Use Device?: No
• Type of Device Usage: Reuse
• Patient Sequence Number: 1