OLYMPUS WINTER & IBE GMBH URETEROSCOPE, 7,5 FR. X 430 MM, 7°, 2 CHANNELS, OCULAR ANGLE 45°; RIGID URETEROSCOPE
|
Back to Search Results |
|
Model Number WA02943A |
Device Problem
Material Twisted/Bent (2981)
|
Patient Problem
Laceration(s) (1946)
|
Event Type
Injury
|
Manufacturer Narrative
|
The suspect device has been returned to olympus for evaluation.The investigation is in process.The olympus service center evaluated the subject device and confirmed the reported event, the device was bent.Once the investigation has been completed, a supplemental report will be submitted with device evaluation results.
|
|
Event Description
|
The customer reported during a procedure, the shaft of the rigid endoscope bent and caused a ureteric partial thickness injury.The surgeon was having difficulty and noted a submucosal flap injury in there ureteral wall and removed then endoscope.After the endoscope was removed, it was identified as bent.The surgeon tried to reinsert the endoscope but could not and completed the procedure with a similar device.There was a 'slight' delay in the procedure to allow for a new endoscope set up.The surgeon placed a stent because of the injury and will follow-up in four weeks to remove the stent.The patient had some hematuria post-operatively which is consistent per the procedure and the injury did not change the patient's course of medication post-operatively.
|
|
Manufacturer Narrative
|
This report is being supplemented to provide additional information based on the legal manufacturer's final investigation.A review of the device history record found no deviations that could have caused or contributed to the reported issue.It has been over 12 years since the subject device was manufactured.Based on the results of the investigation, it is likely that the bent scope was caused by the application of excessive force by the user.Olympus will continue to monitor field performance for this device.
|
|
Manufacturer Narrative
|
This report is being supplemented to provide additional information based on the legal manufacturer's final investigation.Based on the results of further investigation, it is likely that in addition to application of excessive force by the user, the bent scope was also caused by wear and tear.Olympus will continue to monitor field performance for this device.
|
|
Search Alerts/Recalls
|
|
|