Model Number 6913 |
Device Problem
Disconnection (1171)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 01/19/2023 |
Event Type
Injury
|
Manufacturer Narrative
|
Terumo has not received the device for evaluation; therefore, the investigation has yet to be completed.Terumo plans on submitting a follow-up report when the investigation is complete and when more information becomes available.For this reason, terumo references evaluation conclusion code 11.Component code: 4765 - cuvette.Health effect - impact code: 4643 - blood transfusion.Heatlh effect - clinical code: 4582 - no clinical signs, symptoms or conditions.Medical device problem code: 2292 - 1171 - disconnection.Investigation findings: 3233 - results pending completion of investigation.Investigation conclusions: 11 - conclusion not yet available.
|
|
Event Description
|
The user facility reported to terumo cardiovascular that during cardiopulmonary bypass, the h/s disconnect at cuvette.As per the user facility, during bypass, the cdi monitored displayed an h/s disconnect at cuvette message.The cuvette was disconnected and reconnected several times but the message remained.It disappeared at the end of the case when the monitor was switched on and off.The case was conducted without the use of the cuvette.Additionally, the lactate did peak at 3.6mmol/l, the venous saturations and do2 was not measured during the malfunction.An intermittent venous blood gases were done during the case and there was also an elevated lactate; since there was no continuous hb reading, the patient was transfused a 2nd unit of rbcs.The product malfunction did not lead to any apparent harm.*product was not changed out.*procedure completed successfully.
|
|
Manufacturer Narrative
|
This follow-up report is submitted to fda in accord with applicable regulations.Upon further investigation of the reported event, the following information is new and/or changed: d4 (additional device information - added expiration date).G3 (date received by manufacturer).G6 (indication that this is a follow-up report).H2 (follow-up due to additional information and device evaluation).H3 (device evaluated by manufacturer).H4 (device manufacture date).H6 (identification of evaluation codes 10, 11, 3331, 213, 67).Type of investigation #1: 10 - testing of actual/suspected device.Type of investigation #2: 11 - testing of device from same lot/batch retained by manufacturer.Type of investigation #3: 3331 - analysis of production records.Investigation findings: 213 - no device problem found.Investigation conclusions: 67 - no problem detected.The returned sample was visually inspected upon receipt, no anomalies were noted.The sample was connected to a cable head and "operate" was selected on the cdi 500.Values were shown on the monitor and no error message was observed.The sample was disconnected from the cable head and then the h/s disconnect error was observed.A representative retention sample was obtained and tested in the same manner as the returned sample.No error messages were observed.The unit was found to function as intended; therefore, a definitive root cause could not be determined.All available information has been placed on file in quality management for appropriate tracking, trending, and follow-up.
|
|
Manufacturer Narrative
|
This follow-up report is submitted to fda in accord with applicable regulations ¿ and as indicated by terumo cardiovascular systems in the initial report submitted to the fda on february 10, 2023.Upon further investigation of the reported event, the following information is new and/or changed: g6 (indication that this is a follow-up report).H2 (follow-up due to additional information).H3 (device evaluation anticipated by manufacturer - a second follow-up will be submitted upon completion of the investigation and/or submission of new information, thus tcvs references conclusions code 11.).All available information has been placed on file in quality management for appropriate tracking, trending, and follow-up.
|
|
Search Alerts/Recalls
|
|