This report is being submitted in pursuant to the provisions of 21 cfr, part 803.This report may be based on information which has not been able to investigate or verify prior to the required reporting date.This report does not reflect a conclusion by mitek or its employees that the report constitutes an admission that the device, mitek, or its employees caused or contributed to the potential event described in this report.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.H10 additional narrative: d4: the date of expiration is unknown.Udi: (b)(4).Investigation summary : the product was returned to mitek for evaluation.Mitek then conducted visual inspection and functional test of device received.Visual observations revealed that the device had wear marks indicating it was heavily used in the field.The device was found with scratches in distal part and near the tip.The shaft of the device was bent at the mid body.For the functional test, the obturator was assembled in the sheath; as a result, a resistance was felt when trying to assemble and disassemble.Manufacturing record evaluation is not required as the reported event is not associated with the manufacturing process and/or the potential cause of the defect cannot be associated to manufacturing.The manufactured date of this device is 2018 and hence indicates this device is 5 years old.Based on the test results, this complaint can be confirmed.The possible root cause for the bent condition can be related when the device might have been dropped or device was tapped against a hard surface accidentally, as well as rough use.Since this is a reusable device; this damage has possible occurred after use in several procedures.The bent condition of the sheath could have contributed to being unable to assemble.As per ifu- 115828, do not use a damaged or defective endoscope.Inspect the endoscope prior to each examination or procedure and before sterilization based on the instructions in this document; it is important to check the shaft for bending, scratches, dents, corrosion, pitting, or other surface irregularities.Do not hold the endoscope by its shaft; this may cause damage and do not bend the endoscope or subject the endoscope to impact.At this point in time, no corrective action is required, and no further action is warranted.However, in depuy synthes mitek, additional complaint information monitoring for potential safety signals is conducted through complaint trending as part of post market surveillance.
|