Examination of removed implants indicates the cause of the lock screw loosening was related to either rod size selection or placement.The lock screw was tightened onto the faceted portion of the rod.The faceted portion is intended for instrument engagement to aid in placement.Labeling review: potential adverse events and complications ".Potential risks identified with the use of this system, which may require additional surgery, include: bending, fracture or loosening of implant component(s) loss of fixation " warnings, cautions and precautions ".Confirm heights of screws match with patient's lordosis when securing lock screws.Failure to verify screw height following insertion may result in inadequate rod normalization." ".Final-tighten all lock screws with the counter-torque and torque t-handle.Do not final-tighten through other instruments in the set, as the rod may not be able to normalize to the tulip.Ensure there is enough rod overhang when final tightening, and do not lock down on the conical portion of the rod.Failure to do so may lead to improper lock down of the construct.It may be necessary for the surgeon to add length to the rod, depending upon patient anatomy and desired lordosis.".
|
On (b)(6) 2015 a patient underwent a posterior fixation procedure from s1 to l1 with no problems reported.During a later follow-up visit and radiographic review, the right-side lockscrew at s1 was noted to have loosened.On (b)(6) 2016 a revision procedure was performed replacing the screw and lockscrew at right-side s1, as well as both connecting rods.No further problems have been reported.No patient injury was reported.
|