This event has been recorded by zimmer biomet under (b)(4).On may 21, 2018, it was reported that the handpiece stopped while the nurse was checking it on the table before surgery.The customer returned an electric dermatome device, serial number (b)(4), for evaluation.The device history record (dhr) and previous repair report reviewed noted no related non-conformances, requests for deviation, change notices or any other issues with manufacturing or with the device.The dhr and previous repair report review also found that all verifications, inspections and tests were successfully completed.Zimmer biomet surgical has previously repaired/evaluated electric dermatome serial number (b)(4) one time as documented in the repair reports in livelink.The last repair was november 3, 2014 where it was reported that the device stopped suddenly when checked by the nurse and the power cord assembly, power switch, ball detent, thickness lever, reciprocating arm, bearings, seal and retaining ring, motor, o-ring, and damaged head were replaced.This is not a related issue.Product review of the electric dermatome on july 31, 2018 revealed that the calibration was slightly out of calibration at the zero setting only but within at all other settings.The motor speed was with specifications but the motor ran erratically.The customer did not return a power supply for evaluation.Repair of the electric dermatome was performed by zimmer biomet surgical on july 31, 2018 which included replacement of the power cord assembly, power switch, ball detent, thickness lever, reciprocating arm, bearings, seal and retaining ring, motor, o-ring, damaged head, damaged control bar, neck, and calibration shaft.Electric dermatome, serial number (b)(4), was then tested and functioned properly.It was repaired, inspected and tested.The reported event was confirmed since during the product review it was noted that the motor ran erratically.The root cause of the reported event could not be specifically determined with the information that was provided.During the product review it was noted that the motor ran erratically.It is unknown with the information that was provided how this occurred.The investigation was based on the information that was provided initially and any information that was obtained throughout the follow-up process.
|