Returned device is not able to hold screws because one of the distal screw holding tips has broken off.The returned device was manufactured in 2016.Review of the device history records showed that there were no issues at the time of manufacturing of this device and it's sub components that would contribute to the complaint condition.No product design issues or discrepancies were observed during this investigation.The thickness of the distal forcep tip on the returned device near breakage measured 1.00mm which is within specification.The raw material certificate and hardening protocols was confirmed to meet the specification of the device with no relevant non-conformance noted.A definitive assignable root cause for the device breaking could not be determined based on the provided information.This complaint is confirmed however no product design issues or manufacturing discrepancies that would contribute to the reported complaint condition were identified during this investigation.No new, unique or different patient harms were identified as a result of this evaluation.Based on the investigation findings, it has been determined that no corrective and/or preventative action is proposed.Additional monitoring for any potential safety signals will be conducted through complaint trending and other post market safety surveillance activities.Device history lot, part number: 347.985, synthes lot number: t133205, manufacture site: (b)(4), part expiration date: n/a, list of nonconformance¿s: nr-0036109.Further review of the device history records showed that there were no issues at the time of manufacturing of this device and it's sub components that would contribute to the complaint condition.The raw material certificate and hardening protocols was confirmed to meet the specification of the device with no relevant non-conformance noted.Review of the device history record of (b)(4) showed that there were no issues at the time of manufacturing of this device that would contribute to the issue outlined in this complaint.Device was used for treatment, not diagnosis.If information is obtained that was not available for the initial medwatch, a follow-up medwatch will be filed as appropriate.
|
Device report from synthes reports an event in (b)(6) as follows: it was reported that on (b)(6) 2019, the patient underwent an orthopedic procedure.During the procedure, a cannulated hexagonal screwdriver does not engaged on the screw head properly and a holding forceps for cortex screws does not hold items properly.Procedure was successfully completed with two (2) minutes surgical delay.No patient consequence.Concomitant device reported: unknown - screws: trauma (part # unknown, lot # unknown, quantity 1).This report is for one (1) screw and plate holding forceps.This is report 2 of 2 for (b)(4).
|