Model Number 776400 |
Device Problems
Material Deformation (2976); Material Integrity Problem (2978)
|
Patient Problems
Pain (1994); Patient Problem/Medical Problem (2688); No Code Available (3191)
|
Event Date 11/22/2019 |
Event Type
Injury
|
Manufacturer Narrative
|
The investigation is still in progress.Once the investigation is complete, a supplemental report will be filed.
|
|
Event Description
|
It was reported that the inlay stent became knotted at the end of the pigtail during use in the patient.The patient had to be anaesthetized for the stent to be removed, and experienced some pain after removal.
|
|
Manufacturer Narrative
|
The investigation is still in progress.Once the investigation is complete, a supplemental report will be filed.Correction: d4 h11:section a through f - the information provided by bd represents all of the known information at this time.Despite good faith efforts to obtain additional information, the complainant / reporter was unable or unwilling to provide any further patient, product, or procedural details to bd.
|
|
Event Description
|
It was reported that the inlay stent became knotted at the end of the pigtail during use in the patient.The patient had to be anaesthetized for the stent to be removed, and experienced some pain after removal.Per additional information from the ibc via email (b)(6)2020 ; the stent was removed during the original removal surgery, and was replaced with another stent.No further medical intervention was required.
|
|
Event Description
|
It was reported that the inlay stent became knotted at the end of the pigtail during use in the patient.The patient had to be anaesthetized for the stent to be removed, and experienced some pain after removal.Per additional information from the ibc via email 10jan2020; the stent was removed during the original removal surgery, and was replaced with another stent.No further medical intervention was required.
|
|
Manufacturer Narrative
|
The reported event was confirmed as cause unknown.The device failed to meet specifications.The device was being used for treatment.The evaluation of the received photo samples showed a knot at the tip of the pigtail.However, the evidence was not sufficient to determine a definitive root cause.A potential root cause of the reported event could be improper material selection due to which the stent knotted at the end of the pigtail, resulting in patient discomfort, surgical intervention and replacement of device.The device history record was reviewed and found nothing that could have caused or contributed to the reported event.The instructions for use were found adequate and state the following: ¿warning: inspect all guidewires for damage prior to use.Bending or kinking during or prior to placement could damage the guidewire.Do not attempt to use the guidewire if it has been damaged.Use of a damaged wire may result in damage to the urinary tract.Do not reshape the guidewire by any means.Attempting to reshape the guidewire may cause damage resulting in release of fragments into the urinary tract.Failure to exercise proper caution may result in damage to the urinary tract.Do not manipulate or remove the guidewire through a metal cannula or needle.This may result in destruction/ separation of the outer jacket of the wire requiring retrieval.Use extreme caution when using a laser, making sure to avoid contact with the wire.Direct contact could result in damage / breakage to the wire.Attention should be paid to guidewire movement in the urinary tract.Before a guidewire is moved or torqued, tip movement should be examined under direct vision or fluoroscopy.Do not advance or withdraw a guidewire when resistance is encountered as perforation could occur.Sufficient guidewire length must remain exposed to maintain a firm grip on guidewire at all times.Failure to comply with the warnings could result in damage to the guidewire to include, but not limited to: wire breakage, abrasion of the coating, release of guidewire fragments into the urinary system, all of which might require intervention.".
|
|
Search Alerts/Recalls
|