|
H3, h6: the device, used in treatment, was not returned for evaluation.Therefore, product analysis could not be performed at this time.So the reported event could not be confirmed.A medical investigation was conducted and confirms reportedly the ¿poor rom¿ secondary to incomplete rehab/severe burns was the root cause of the arthroscopy/revision.The patient impact beyond the reported symptoms and subsequent arthroscopy/revision could not be determined.Although the complaint indicated there was good rom on the table, the actual procedure achieved only ¿minimum results¿ post-operatively per complaint/ response.No further medical assessment can be rendered at this time.Should additional clinical documentation become available in the future, the clinical/medical task may be re-evaluated.No further medical assessment is warranted at this time.A review of the risk management file revealed this failure mode was previously identified.Factors and/or some potential probable causes that could contribute to the reported event have been identified as overuse or excessive pressure on the joint, injury, infection and/or patient condition.At this time, we have no reason to suspect that the product failed to meet any product specifications at the time of manufacture.Based on this investigation, the need for corrective action is not indicated.Without the actual product involved and/or device information, our investigation cannot proceed.If the device or new information is received in the future, this complaint can be re-opened.No further actions are being taken at this time.We consider this investigation closed.
|