OLYMPUS WINTER & IBE GMBH JAWS INSERT "HICURA", 5 X 330, JOHANN, BIPOLAR; HAND INSTRUMENTS, STANDARD, BIPOLAR AND MONOPOLAR
|
Back to Search Results |
|
Model Number WA69410M |
Device Problem
Arcing (2583)
|
Patient Problem
No Clinical Signs, Symptoms or Conditions (4582)
|
Event Date 11/22/2022 |
Event Type
malfunction
|
Manufacturer Narrative
|
The suspect medical device has not yet been returned to olympus for evaluation/investigation.Therefore, the exact cause of the user's experience and the reported phenomenon could not be determined and is being judged as unknown.However, if the suspect medical device is returned for evaluation/investigation or additional significant information becomes available, this report will be updated.
|
|
Event Description
|
Olympus was informed that after only use in a laparoscopic prostatectomy procedure the jaws insert began to produce an electric arc to the soft tissues in the area of the ceramic insulation.No further information was provided but there was no report about an adverse event or patient injury.
|
|
Manufacturer Narrative
|
The suspect medical device was returned to the manufacturer for investigation.The investigation confirmed the reported damage to the jaws at the device¿s distal end.The ceramic axle was found to be broken and the teflon body was damaged due to burnings.These damages were very likely caused by improper handling.Most likely, an excessive current flashover occurred due to a short circuit, which was caused by either unintended contact with other equipment, or because the distal jaws had permanent contact during high-frequency use without any contact to tissue.Thus, these findings can be attributed to use error.In addition, the proximal end of the jaws was found deformed, which was most likely caused by improper handling (excessive force).The device might have been combined incorrectly and thus excessive force was exerted on the device.Due to this deformation, the overload protection will no longer be triggered correctly.Furthermore, the distal end showed a biofilm which was most likely caused by incorrect reprocessing and can thus also be attributed to use error.A material or quality problem can be excluded since a manufacturing and quality control review was performed for the affected lot number of the jaws insert without showing any abnormalities.The case will be closed from olympus side with no further actions, but the reported event/incident will be recorded for trending and surveillance purposes.Furthermore, the user will be informed about the investigation results.
|
|
Search Alerts/Recalls
|
|
|