|
The device was returned and evaluated by olympus.In addition to the findings in b5, evaluation found the complaint was confirmed and water tightness was lost due to a pinhole on the bending section cover.Also, evaluation found the bending section cover adhesive was chipped, the bending angle in the up direction did not meet the standard value due to wear of the angle wire, the light guide lens was cracked, the connecting tube was dented, the venting connector under the grip was shaved, and multiple parts of the scope were scratched.A review of the device history record found no deviations that could have caused or contributed to the reported issue.There was no indication that the event was caused by a misuse or that the event was related to design of the device.Repair history was reviewed and no issues were found related to the reported event.The device was not repaired within the past year.Although it was determined that the defect was likely caused by stress of repeated use, external factors, or handling, a definitive root cause of the peeled coating could not be identified the instruction manual operation manual ¿chapter 3 preparation and inspection, 3.2 preparation and inspection of the endoscope¿ describes the following warning.1.Visually inspect the control section for excessive scratching.2.Visually inspect the boot and the insertion tube near the boot for bends, twists or other irregularities.3.Visually inspect the surface of the insertion tube for dents, bulges, swelling, peeling or other irregularities.4.Carefully run your fingertips over the entire length of the insertion tube.Inspect for any protruding objects or other irregularities.If additional information becomes available at a later date, this report will be supplemented.Olympus will continue to monitor the field performance of this device.
|