MAUDE Adverse Event Report: MEDOS INTERNATIONAL SARL DELTAPAQ CERE 1.5MMX2CM; NEUROVASCULAR EMBOLIZATION DEVICE

Catalog Number	CDF10015230
Medical Device Problem Codes	Stretched (1601); Failure to Advance (2524)
Health Effect - Clinical Code	No Clinical Signs, Symptoms or Conditions (4582)
Date of Event	07/18/2022
Type of Reportable Event	Malfunction
Additional Manufacturer Narrative
Product complaint # (b)(4).Information regarding patient weight, height, medical history, race, and ethnicity was not reported.Section d2b ¿ procode: krd/hcg.Section e1.Initial reporter phone: (b)(6).Section h3 - the device is available to be returned for evaluation and testing.However, it has not been received to date as indicated as ¿other¿ in this section as the reason for non-evaluation.If the device returns, a device investigation will be performed.Missing information from this report is identified as blank; this information was not provided in the reported event or available at the time of report submission.This report is being submitted pursuant to the provisions of 21 cfr, part 803 (and/or part 4, as applicable).This report may be based on information which has not been investigated or verified prior to the required reporting date.This report does not reflect a conclusion by cerenovus, or its employees that the report constitutes an admission that the product, cerenovus, or its employees caused or contributed to the potential event described in this report.If information is obtained that was not available for the initial report, a follow-up report will be filed as appropriate.
Event or Problem Description
As reported by the field, during an endovascular embolization, a deltapaq cere 1.5mmx2cm coil (cdf10015230, 30432657) became impeded in an unspecified microcatheter (mc) and could not pass through the mc.The physician removed the coil from the patient and observed that the coil was unraveled/stretched.A new coil was switched to complete the surgery.The microcatheter was not replaced.There was no patient injury reported.
Additional Manufacturer Narrative
Product complaint # (b)(4).Complaint conclusion: as reported by the field, during an endovascular embolization, a deltapaq cere 1.5mmx2cm coil (cdf10015230, 30432657) became impeded in an unspecified microcatheter (mc) and could not pass through the mc.The physician removed the coil from the patient and observed that the coil was unraveled/stretched.A new coil was switched to complete the surgery.The microcatheter was not replaced.There was no patient injury reported.A non-sterile deltapaq cere 1.5mmx2cm coil was received contained in the decontamination pouch.Upon receiving the device, a visual inspection was performed, and it was noted that the coil was returned outside the introducer.Under magnification, the embolic coil was found to be stretched on the proximal portion.However, this remains attached to the resistance heating (rh), which was noted to be not softened.Some dried biological/saline solution residues were found on the rh.No other damages were noted in the device.The issue documented a coil that could not pass through the microcatheter was confirmed based on the appearance of the returned device.The stretched damage observed in the coil was the result of the impeded condition experienced during the procedure that could not be replicated in the laboratory.Stretching can occur during procedure handling where force may have been inadvertently applied.According to the risk documentation, friction and difficulty to advance are potential issues that can occur during microcoil placement due to continuous saline flush not being established, which can result in coil stretching.Coil stretching is a known potential issue associated with the use of this device.The instructions for use (ifu) provide proper handling instructions for the device to prevent such issues from occurring.There is no indication that the issue reported is a result of a defect inherently related to the device.As part of cerenovus quality process, all devices are manufactured, inspected, and released to approved specifications.Therefore, no capa activity is required.A manufacturing record evaluation was performed for the finished device 30432657 number, and no non-conformances related to the malfunction were identified.It should be noted that multiple factors could cause product failure.The instructions for use (ifu) contain the following precautions: if unusual friction is noticed during advancement or retraction of the microcoil system through the introducer, open the rhv main valve, and partially withdraw the distal end of the introducer to expose its tip within the rhv.Tighten the rhv main valve and flush the y-connector of the rhv with sterile saline and verify that fluid exits the slit in the clear portion of the introducer.If unusual friction is still noticed during advancement or retraction of the microcoil system, verify flush lines are open and properly pressurized.Then slowly withdraw the entire microcoil system and examine for damage.Replace it with a new microcoil system.If friction still exists, withdraw and examine the delivery catheter system.If repositioning of the microcoil is necessary, carefully observe the motion of the microcoil in respect to the dpu wire while retracting the microcoil under fluoroscopy.If the microcoil movement is not one-to-one with the dpu wire, or if repositioning is difficult, the microcoil may have become stretched and could possibly break.Gently remove and discard the microcoil system.As part of the post market surveillance program, information from this complaint is trended to identify statistical signals for consideration of further correction action.Since there was no evidence to suggest the event was related to a manufacturing or design issue, no corrective actions will be taken at this time.A supplemental report will be submitted if new facts arise which materially alter information submitted in a previous mdr report.
Additional Manufacturer Narrative
Product complaint # (b)(4).The product has been returned for evaluation and testing; however, the engineering evaluation has not been completed.A supplemental report will be submitted if new facts arise which materially alter information submitted in a previous mdr report.

• Brand Name: DELTAPAQ CERE 1.5MMX2CM
• Common Device Name: NEUROVASCULAR EMBOLIZATION DEVICE
• Manufacturer (Section D): MEDOS INTERNATIONAL SARL; chemin-blanc 38; le locle neuchatel CH-24 00; SZ CH-2400
• Manufacturer (Section G): CERENOVUS INC. (FREMONT); 47709 fremont blvd; fremont CA 94538
• Manufacturer Contact: kate karberg ; 31 technology dr; irvine, CA 92618 ; 3035526892
• MDR Report Key: 18640125
• Report Number: 3008114965-2024-00179
• Device Sequence Number: 15464335
• Product Code: HCG
• UDI-Device Identifier: 00878528007012
• UDI-Public: 00878528007012
• Combination Product (Y/N): N
• Initial Reporter Country: CH
• PMA/510(K) Number: K080437
• Number of Events Summarized: 1
• Summary Report (Y/N): N
• Serviced by Third Party (Y/N): Unknown
• Reporter Type: Manufacturer
• Report Source: Foreign,Health Professional
• Initial Reporter Occupation: Other Health Care Professional
• Type of Report: Initial,Followup,Followup
• Report Date (Section B): 03/07/2024

1 Device was Involved in the Event

1 Patient was Involved in the Event

• Is this an Adverse Event Report?: No
• Is this a Product Problem Report?: Yes
• Operator of Device: Health Professional
• Device Expiration Date: 08/31/2025
• Device Catalogue Number: CDF10015230
• Device Lot Number: 30432657
• Was Device Available for Evaluation?: Device Returned to Manufacturer
• Is the Reporter a Health Professional?: Yes
• Type of Report(Section G): Thirty-Day
• Initial Date Received by Manufacturer: 01/17/2024
• Supplement Date Received by Manufacturer: 02/09/2024; 03/06/2024
• Initial Report FDA Received Date: 02/05/2024
• Supplement Report FDA Received Date: 02/26/2024; 03/07/2024
• Was Device Evaluated by Manufacturer? (Y/N): Yes
• Date Device Manufactured: 09/02/2020
• Is the Device Labeled for Single Use? (Y/N): Yes
• Is This a Single-Use Device that was Reprocessed and Reused on a Patient? (Y/N): No
• Usage of Device: Initial
• Patient Sequence Number: 1
• Concomitant Medical Products and Therapy/Usage Dates: MICROCATHETER (UNSPECIFIED BRAND).
• Patient Sex: Unknown