MAUDE Adverse Event Report: AOMORI OLYMPUS CO., LTD. SINGLE USE 3-LUMEN SPHINCTEROTOME V; SINGLE USE 2-LUMEN SPHINCTEROTOME

Model Number	KD-V411M-0725
Medical Device Problem Code	Break (1069)
Health Effect - Clinical Code	No Clinical Signs, Symptoms or Conditions (4582)
Date of Event	04/18/2024
Type of Reportable Event	Malfunction
Additional Manufacturer Narrative
The evaluation of the event is ongoing.Should additional relevant information become available, a supplemental report will be submitted.
Event or Problem Description
It was reported the knife of the single use 2-lumen sphincterotome was broken after an electrical current error occurred during the second incision.The issue occurred during a therapeutic est (endoscopic sphincterotomy) procedure.The procedure was completed using a similar device.There were no reports of patient harm.
Additional Manufacturer Narrative
This supplemental report is being submitted to provide the results of the legal manufacturer's final investigation.Additional information added to fields d9, h3, h4 and h6.A review of the device history record found no deviations that could have caused or contributed to the reported issue.It has been less than 1 year since the subject device was manufactured.The device was returned to olympus for inspection, and the customer's reportable malfunction was confirmed.Device evaluation found the cutting wire was broke and the broken portion was scorched and melted.Based on the results of the investigation, it is likely the following led to the malfunction: 1.The device was not protruded enough from the endoscope until the rear end of the cutting wire was in the field of view.2.Due to the situation of ¿1¿ description, the cutting wire and the endoscope were being close to each other.3.The output was activated in state of ¿2¿ description.This might have led to an electrical discharge between the cutting wire and the distal end of the endoscope.4.An electrical discharge possibly occurred, and the cutting wire became hot instantly.That might have caused the cutting wire to break.5.Since the cutting wire was broken, it was felt that the cutting wire was no longer energized.The event can be detected and prevented by following the instructions for use: - since the cutting wire is very thin, it may break off in the following cases: the distance between the papilla of vater and the cutting wire is very short, the output is too high or activated while the cutting wire touches metal parts of the endoscope, or the cutting wire is tightened too strong.When the cutting wire breaks off, its proximal end will be retracted toward the endoscope if the slider is pulled.If the slider is pushed, the cutting wire will be pushed out toward the papilla or move sideways.If the cutting wire breaks off, stop the output immediately and pull the slider completely to retract the broken cutting wire into the tube.Then withdraw the sphincterotome from the papilla.Otherwise, patient injury, such as perforations, bleeding, or lacerations within the biliary duct, and/or damage of the endoscope could result.- be sure that the rear end of the cutting wire is extended from the distal end of the endoscope.Insufficient output or unintended tissue injury may occur in case the cutting wire contacts the forceps elevator.Olympus will continue to monitor field performance for this device.

• Brand Name: SINGLE USE 3-LUMEN SPHINCTEROTOME V
• Common Device Name: SINGLE USE 2-LUMEN SPHINCTEROTOME
• Manufacturer (Section D): AOMORI OLYMPUS CO., LTD.; 2-248-1 okkonoki; kuroishi-shi, aomori 036-0 357; JA 036-0357
• Manufacturer (Section G): AOMORI OLYMPUS CO., LTD.; 2-248-1 okkonoki; kuroishi-shi, aomori
• Manufacturer Contact: todd brill ; 800 west park drive; westborough, MA 01581 ; 5082077661
• MDR Report Key: 19237165
• Report Number: 9614641-2024-01028
• Device Sequence Number: 18124665
• Product Code: KNS
• UDI-Device Identifier: 04953170382635
• UDI-Public: 04953170382635
• Combination Product (Y/N): N
• Initial Reporter Country: JA
• PMA/510(K) Number: K950166
• Number of Events Summarized: 1
• Summary Report (Y/N): N
• Serviced by Third Party (Y/N): Unknown
• Reporter Type: Manufacturer
• Report Source: Foreign,User Facility
• Initial Reporter Occupation: Non-Healthcare Professional
• Type of Report: Initial,Followup
• Report Date (Section B): 05/23/2024

1 Device was Involved in the Event

1 Patient was Involved in the Event

• Is this an Adverse Event Report?: No
• Is this a Product Problem Report?: Yes
• Operator of Device: Health Professional
• Device Model Number: KD-V411M-0725
• Device Lot Number: 39V
• Was Device Available for Evaluation?: Device Returned to Manufacturer
• Was the Report Sent to FDA?: No
• Type of Report(Section G): Thirty-Day
• Initial Date Received by Manufacturer: 04/18/2024
• Supplement Date Received by Manufacturer: 05/17/2024
• Initial Report FDA Received Date: 05/03/2024
• Supplement Report FDA Received Date: 05/23/2024
• Was Device Evaluated by Manufacturer? (Y/N): Yes
• Date Device Manufactured: 09/21/2023
• Is the Device Labeled for Single Use? (Y/N): Yes
• Is This a Single-Use Device that was Reprocessed and Reused on a Patient? (Y/N): No
• Usage of Device: Initial
• Patient Sequence Number: 1
• Patient Sex: Unknown