MAUDE Adverse Event Report: AOMORI OLYMPUS CO., LTD. SINGLE USE 3-LUMEN SPHINCTEROTOME V; SINGLE USE 2-LUMEN SPHINCTEROTOME

Model Number	KD-V411M-0725
Medical Device Problem Code	Break (1069)
Health Effect - Clinical Code	No Clinical Signs, Symptoms or Conditions (4582)
Date of Event	10/22/2024
Type of Reportable Event	Malfunction
Event or Problem Description
It was reported that the 3-lumen sphincterotome v knife wire broke while cutting the nipple.It did not fall out inside the body.A separate stock was opened and the procedure was completed without any problems.The issue occurred during the procedure.The procedure was therapeutic.There were no reports of patient harm.
Additional Manufacturer Narrative
To date, the device has not been returned.Should additional relevant information become available, a supplemental report will be submitted.
Additional Manufacturer Narrative
This report is being supplemented to provide additional information based on the legal manufacturer's final investigation.Corrected field: d4 udi.Updated fields: d8, d9, h3, h4.A review of the device history record found no deviations that could have caused or contributed to the reported issue.The device was returned to olympus for inspection, and the reportable malfunction was not confirmed.Based on the results of the investigation, it is likely the following led to the malfunction: the cutting wire where the wire coating was torn came into contact with the distal end of the endoscope when the forceps elevator was raised.In addition, the cutting wire became hot instantly at the contact point when an electric conduction was activated.A definitive root cause could not be determined.The event can be [detected/prevented] by following the instructions for use which state: this instruction manual contains the following information.(drawing no.Rk2599 revision no.2) since the cutting wire is very thin, it may break off in the following cases: the distance between the papilla of vater and the cutting wire is very short, the output is too high or activated while the cutting wire touches metal parts of the endoscope, or the cutting wire is tightened too strong.When the cutting wire breaks off, its proximal end will be retracted toward the endoscope if the slider is pulled.If the slider is pushed, the cutting wire will be pushed out toward the papilla or move sideways.If the cutting wire breaks off, stop the output immediately and pull the slider completely to retract the broken cutting wire into the tube.Then withdraw the sphincterotome from the papilla.Otherwise, patient injury, such as perforations, bleeding, or lacerations within the biliary duct, and/or damage of the endoscope could result.When inserting the instrument into the endoscope, be sure that the cutting wire is parallel to the tube.Otherwise, the metal part of the forceps elevator may contact the cutting wire and peel off the coating material.Do not activate output while tissue is in contact with the torn or damaged coated portion of the distal end.If output is activated while tissue is contacting the torn or damaged coated portion due to insertion into or withdrawal from an endoscope, leakage current, decreased output, and/or thermal injury could result.If you feel the cutting is blunt, withdraw the device from the scope to examine if there is any peel off and tear at the coating portion.Olympus will continue to monitor field performance for this device.

• Brand Name: SINGLE USE 3-LUMEN SPHINCTEROTOME V
• Common Device Name: SINGLE USE 2-LUMEN SPHINCTEROTOME
• Manufacturer (Section D): AOMORI OLYMPUS CO., LTD.; 2-248-1 okkonoki; kuroishi-shi, aomori 036-0 357; JA 036-0357
• Manufacturer (Section G): AOMORI OLYMPUS CO., LTD.; 2-248-1 okkonoki; kuroishi-shi, aomori
• Manufacturer Contact: todd brill ; 800 west park drive; westborough, MA 01581 ; 5082077661
• MDR Report Key: 20522756
• Report Number: 9614641-2024-02032
• Device Sequence Number: 9171037
• Product Code: KNS
• UDI-Device Identifier: 04953170380587
• UDI-Public: 04953170380587
• Combination Product (Y/N): N
• Initial Reporter Country: JA
• PMA/510(K) Number: K950166
• Number of Events Summarized: 1
• Summary Report (Y/N): N
• Serviced by Third Party (Y/N): N
• Reporter Type: Manufacturer
• Report Source: Foreign,Health Professional,User Facility
• Initial Reporter Occupation: Physician
• Type of Report: Initial,Followup
• Report Date (Section B): 11/18/2024

1 Device was Involved in the Event

1 Patient was Involved in the Event

• Is this an Adverse Event Report?: No
• Is this a Product Problem Report?: Yes
• Operator of Device: Health Professional
• Device Model Number: KD-V411M-0725
• Device Lot Number: 45V
• Was Device Available for Evaluation?: Device Returned to Manufacturer
• Is the Reporter a Health Professional?: Yes
• Was the Report Sent to FDA?: No
• Type of Report(Section G): Thirty-Day
• Initial Date Received by Manufacturer: 10/22/2024
• Supplement Date Received by Manufacturer: 11/14/2024
• Initial Report FDA Received Date: 10/24/2024
• Supplement Report FDA Received Date: 11/19/2024
• Was Device Evaluated by Manufacturer? (Y/N): Yes
• Date Device Manufactured: 05/20/2024
• Is the Device Labeled for Single Use? (Y/N): Yes
• Is This a Single-Use Device that was Reprocessed and Reused on a Patient? (Y/N): No
• Usage of Device: Initial
• Patient Sequence Number: 1
• Concomitant Medical Products and Therapy/Usage Dates: TJF-Q290V
• Patient Sex: Unknown