|
While no serious injury resulted in this event, if this malfunction recurred, it could cause or contribute to a serious injury or require medical or surgical intervention to preclude such.This event, therefore, is reportable per 21cfr part 803.Usb 3 firmware v1.4 contains an issue in the portion of code used to optimize sensor performance.If the optimization occurs during an exposure or sensor readout, there is a chance that the resulting image will be corrupted.Image data following the point of corruption will consist of data that was previously held in the memory of the usb device.As a result, the presented image may contain a portion of data from a previous exposure.In general, this would be obvious to the user since the presented image would either contain obvious artifacts or different anatomy than expected.Field service evaluation- note 02/03/2026 16:16:50 (b)(6), further action 02/03/2026 4:06:24 pm (dentsply sirona charlotte time) caller's full name: (b)(6) caller's phone number: caller's role: patterson tech warranty status: billing previously accepted: problem description: washed out image after replacing cable ( image attached) troubleshooting description: had him remove cable clean contacts on both sides and try again-- 2-3-2026 took 4 images all look good with # 25070655--advised to monitor the situation to see if it happens again, replace sensor solution description 01/27/2026 17:35:08 (b)(6)--------initial log-------- 01/27/2026 4:42:49 pm (dentsply sirona charlotte time) warranty: yes dealer on-site: yes.Billable: no.No patient was reported harm due to images troubleshooting description: tech replaced the elastomeric strip and cable recommend ordering a replacement.
|
|
While the customer was using a part of an intraoral sensor system, schick33 s2 sensor ship kit/3.0 cable 9', they allege experiencing image quality issues when an x-ray image was taken and an additional image was required.No injury was reported from the alleged event.
|