|
Product complaint # (b)(4).Date sent to the fda: 3/11/2026.H6 component code: g07002 - no device problem found.This report is being submitted pursuant to the provisions of 21 cfr, part 803.This report may be based on information which has not been investigated or verified prior to the required reporting date.This report does not reflect a conclusion by ethicon, or its employees that the report constitutes an admission that the product, ethicon, or its employees caused or contributed to the potential event described in this report.If information is obtained that was not available for the initial report, a follow-up report will be filed as appropriate.A manufacturing record evaluation was performed for the finished device lot, and no non-conformances were identified.Attempts are being made to obtain the following information.To date no response has been provided.If further details are received at a later date a supplemental medwatch will be sent: ¿ how many devices demonstrated the alleged deficiency? ¿ did the event occur during one or multiple patient procedures? ¿ what is the total number of procedures? ¿ have any of these events been previously reported to ethicon? if so, could you please provide the corresponding reference number(s)? ¿ when was the needle detached/pulled off from the suture (in the package, during removal from package, during handling prior to use on patient or during use on the patient)? please specify.¿ please provide the source or name and title of external person providing answers to follow-up (external person submitting answers to sales rep).H3 investigational summary: the product was returned to eth for evaluation.Visual inspection revealed that one open box with twenty (20) unopened samples was received for analysis.Product code z333h.As per the sampling plan, a visual inspection was performed on thirteen samples, and the packets were opened.The swage and attachment area were noted to be as expected.The sutures were dispensed without problems and examined along the strand no anomalies were observed during evaluation.The functional test was performed using instron equipment and the pull force result was above the minimum requirements.As part of eth quality process, all devices are manufactured, inspected, and released to approved specifications.The event described could not be confirmed as the device performed without any difficulties noted.Although no product defect was identified, there may have been other circumstances or issues that occurred during the use of the device that could not be replicated during the laboratory analysis.Additional complaint information monitoring for potential safety signals is conducted through complaint trending as part of post-market surveillance.
|