|
The hospital reported that the hst iii system (3.8 mm) was loaded normally according to the instructions for use (ifu), but the seal became caught on the tip of the loader, preventing smooth removal and attachment.Deeming the product to be a mechanical defect, it was immediately replaced with a new one.Reloading and attachment were subsequently performed normally, allowing the surgery to be completed without a hitch.
|
|
Tw (b)(4).Updated sections: b4, d9, g3, g6, h2, h3, h6, h11.The device was returned to the factory for evaluation on 03/25/2026.An investigation was conducted on 03/30/2026.A visual inspection was conducted.Signs of clincal use and no evidence of blood was observed.The delivery device was returned inside the loading device with the white plunger not depressed and the blue safety lock on, which prevents the white plunger from being depressed.The delivery device was removed from the loading device with no physical or visual difficulites observed.The seal and tension spring assembly remained inside the loading device.The seal and tension spring assembly was removed from the loading device with no physical or visual difficulties observed.There were no cracks or delamiantion observed on the intact seal or tension spring assembly.Measurements of the delivery device were taken; the inner diameter was measured at 0.196 inches, the outer diameter was measured at 0.220 inches (rm2036883).The length of the delivery tube was measured at 2.49 inches (mcv00004217).The measurement values recorded for the delivery tube were within the tolerance specifications.Based on the returned condition of the device as well as the evaluation results, the reported failure "fitting problem" was confirmed.The lot # 3000459889 history record review was completed.There were no ncmrs, rework, or deviations documented for the reported lot number.Based on the dhr/lhr review results, it was determined that there is no relation between the batch manufacturing process and the reported failure.Specific actions for the reported failure mode are being maintained and documented under maquet's corrective and preventive action (capa) system.
|