Catalog Number THS-LS-C |
Device Problem
Detachment of Device or Device Component (2907)
|
Patient Problem
Embolism (1829)
|
Event Date 11/12/2018 |
Event Type
Injury
|
Manufacturer Narrative
|
If information is provided in the future, a supplemental report will be issued.
|
|
Event Description
|
Physician used a turbohawk device with a spider fx embolic protection device during treatment of a 70mm, 90% stenosed moderately calcified lesion in the patient¿s mid superficial femoral artery (sfa) of diameter 5mm.Vessel described as being non-tortuous.Ifu was followed and the device was prepped without issue.The vessel was pre-dilated.It is reported during withdrawal of the device following second advancement, severe resistance was felt, and the tip separated at the hinge pin.The tip is reported to have embolised at the target lesion.It has been reported the tip was ¿pulled out of the body normally¿.A vessel dissection was also reported.The device was replaced and the procedure was completed.
|
|
Manufacturer Narrative
|
Additional information: while the detachment occurred during the procedure, no portion detached in the patients and was observed fol lowing removal of the device from the patient.If information is provided in the future, a supplemental report will be issued.
|
|
Manufacturer Narrative
|
Additional information: email address product analysis the turbohawk was returned inside a clear bio-hazard bag with a tweezers and a distal flush tool.No ancillary devices were received.During visual inspection it was noted that the cutter blank was visible within the cutter window and that the platinum iridium of the distal rim of the cutter window was bent/curved outwards.The platinum iridium of the housing was bent and was shifted to the side.The housing was not aligned with the proximal area of the cutter window.Functional testing was performed.The thumb switch was retracted and the cutter pulled back to the proximal end of the cutter window as intended.The thumb switch was advanced, however the turbohawk could not complete a packing stroke.The rim of the cutter could not pass through the cutter window as the rim of the cutter was making contact with the bent portion of the platinum iridium.If information is provided in the future, a supplemental report will be issued.
|
|
Search Alerts/Recalls
|