It was reported that the procedure was performed to treat a lesion in the mid left anterior descending coronary artery.An unspecified 6f guiding catheter was placed.A 2.50 x 12 mm nc trek rx balloon dilatation catheter (bdc) was attempted to be advanced; however, resistance with the guiding catheter was met and the proximal shaft bent.Force was applied and the shaft broke [separated].The separation occurred at a point outside of the patient anatomy and the distal part was simply removed.A new 2.50 x 12 mm nc trek rx bdc was advanced; however, the same problem occurred.A new unspecified device was used with the same guiding catheter to successfully complete the procedure.There were no adverse patient effects and no clinically significant delay in the procedure.No additional information was provided.
|
Exemption number e2019001.The device was not returned for evaluation.A review of the lot history record identified no manufacturing nonconformities issued to the reported lot that would have contributed to this event.Additionally, a review of the complaint history of the reported lot did not indicate a lot specific quality issue.It should be noted that the coronary dilatation catheters (cdc), nc trek rx, global, instruction for use (ifu), states: if resistance is felt, determine the cause before proceeding.Continuing to advance or retract the catheter while under resistance may result in damage to the vessels and / or damage / separation of the catheter.In this case, it is likely that the violation of the ifu contributed to the reported separation as the device separated after force was applied.The investigation was unable to determine a conclusive cause for the reported difficulty advancing the device; however, the reported kink appears to be related to circumstances of the procedure.The reported shaft separation appears to be related to user error.There is no indication of a product quality issue with respects to the design, manufacture, or labeling of the device.
|